4. Hardware and Software Setup
4.1. Vehicle Spy Installation
- Run the Vehicle Spy installer from the CD-ROM or from the download link
- Select Language
- Start Vehicle Spy setup wizard
- Review and accept license agreement
- Select installation type (new or repair … most cases will be new)
- Select destination location (we recommend the default location)
- Select Start Menu folder (we recommend the default location)
- Review installation options and begin installation
- Install VCP Drivers
- Install WinPcap
- Install ICS port Drive
4.2. Hardware Connections
Termination. Please note the EtherBADGE does not have built-in selectable termination resistors. Therefore, an external resistor (120 ohm) is required on the CAN-H and CAN-L pins as shown below. The device you are connecting to also needs the termination resistor. Most of the Intrepid Control System devices have built-in selectable termination resistors that can be enabled via the hardware setup for that device. If this option is not available, then add the external resistor as shown below.