4. Hardware and Software Setup

4.1. Vehicle Spy Installation

  1. Run the Vehicle Spy installer from the CD-ROM or from the download link

  2. Select Language

  3. Start Vehicle Spy setup wizard

  4. Review and accept license agreement

  5. Select installation type (new or repair … most cases will be new)

  6. Select destination location (we recommend the default location)

  7. Select Start Menu folder (we recommend the default location)

  8. Review installation options and begin installation

  9. Install VCP Drivers

  10. Install WinPcap

  11. Install ICS port Drive

4.2. Hardware Connections

The following diagram will show the minimum connection to the neoECU-12 in order to configure it and program the CoreMini of the device. Connect to HS CAN 1 of the neoECU-12. You can also use the neoECU 12 programming board from Intrepid, you can purchase the optional board separately https://store.intrepidcs.com/product/neoecu-12-pb.

_images/neoEcu12.png

Termination. Please note the neoECU-12 does not have built-in selectable termination resistors. Therefore, an external resistor (120 ohm) is required on the CAN-H and CAN-L pins as shown below. The device you are connecting to also needs the termination resistor. Most of the Intrepid Control System devices have built-in selectable termination resistors that can be enabled in via the hardware setup for that device. If this option is not available, then add the external resistor as shown below.

_images/neoEcu12-1.png