Valid parameter names for the SetDeviceParameter and GetDeviceParameter methods¶
The sections below list all of the valid device parameters for each supported neoVI device.
neoVI Fire Parameters¶
The valid parameters for a neoVI Fire device are listed below. See SFireSettingsStructure for a listing of the valid values for each parameter.
valueCAN3 Parameters¶
CAN Network Parameters¶
The valid parameters for CAN network settings on a neoVI device are listed below. Substitue the number of the CAN channel on the device for the ‘x’ . The current valid CAN network specifiers are can1 through can4, depending the capabilities of the device. See CAN_SETTINGSStructure for a listing of valid values for each parameter.
Single Wire CAN Network Parameters¶
The valid parameters for single wire CAN network settings on a neoVI device are listed below. See SWCAN_SETTINGSStructure for a listing of valid values for each parameter.
LIN Network Parameters¶
The valid parameters for a LIN network on a neoVI device are listed below. Substitute the number of the LIN channel on the device for the ‘x’. The current valid LIN network specifiers are lin1 through lin4. See LIN_SETTINGSStructure for a listing of valid values for each parameter.
ISO9141_KWP Network Parameters¶
The valid parameters for the ISO9141_KWP Network are listed below. For the iso9141_kwp_settings/init_steps/x/ parameters, substitute the number of the desired step for the ‘x’. The current valid init_steps range is 0 through 15, for a total of 16 steps.