Figure 1 - The neoVI has three settings inside the box.
Hardware Settings
Main
Applies to
neoVI Red and neoVI FIRE
While most neoVI settings are software programmable a few are set with hardware. The termination resistors for low speed fault tolerant CAN set in hardware. Table 1 and Figure 1 explain how to make these settings.
Table 1 - Hardware Settings in the neoVI device
| Setting |
Bubble in Figure 1 |
Instructions |
| Low Speed Fault Tolerant CAN Termination | A | Insert two 0.25 W resistors end to end in the sockets. See terminating a Low Speed Fault Tolerant CAN network for details. |
Figure 1 - The neoVI has three settings inside
the box.
| neoVI Documentation - (C) Copyright 2000-2020 Intrepid Control Systems, Inc. |
Last Update: Thursday, July 09, 2009