The CoreMini Console is found under 'Tools'. This is where scripts can be loaded or removed from the hardware.
The CoreMini Console has a lot of information regarding the setup that is to be
transferred. (Figure2: )
shows the output list. This list will notify you of any errors or warnings. If any
problems exist in the script, a red dot will be next to that item to warn you that
something is wrong. The "Send to USB Device" section marked by
(Figure2:
)lets you setup
where to send the script. The Device section selects which of the connected hardware
to send the script to. The Storage section lets you choose where to store the script.
For Playback and Capture scripts, the"SD Card" must be used. The "Run
CoreMini After Download"checkbox
(Figure2:
)tells the
hardware if it should run the script after it is loaded. If this is unchecked, the
script will not run until the unit is re-powered. The Send button
(Figure2:
) will send the
script to the hardware.
Scripts can be removed from the hardware by using the Clear button
(Figure2: ). Once a script
has been removed from the hardware, the script must be sent to the hardware again in
order to run it.