1. FCC/IC Details




1.1. FCC/IC Statements

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference nearby equipment, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures.

  • Reorient or relocate the product.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult Intrepid Control Systems, Inc. Customer Support.

Safety Notices

  1. “Only the approved module antenna is used with the radio product.”
  2. “The neoVI RED 2 product and antenna shall not be operated within 20cm of the human body inline with the radio module’s “mobile” exposure compliance requirements.”

RF Exposure

To comply with FCC/IC RF exposure requirements for mobile transmitting devices, this transmitter should only be used or installed at locations where there is at least 20 cm separation distance between the antenna and all persons. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any interference, including interference that may cause undesired operation of the device.

RF Exposure

Conformement aux normes d’lndustrie Canada, ce transmetteur radio ne peut fonctionner qu’avec une antenne dont le type et le gain maxiumum sont approuves par lndustrie Canada. Pour reduire les risques d’inteferences radio encourus par d’autres utilisateurs, le type et le gain de l’antenne doivent etre choisis de fac;:on ace que la puissance rayonnee isotrope equivalente (PIRE) ne soit pas superieure a celle necessaire pour etablir une bonne communication. Cet appareil est conforme norme lndustrie Canada RSS exempts de licence (s). Son fonctionnement est soumis aux deux conditions suivantes:

  1. cet appareil ne doit pas provoquer d’interferences, et
  2. cet appareil doit accepter toute interference, y compris les interferences pouvant provoquer un fonctionnement indesirable de l’appareil.